The No. 1 MC is our right angle handpiece built to do the job. Head spindle is mounted in a roller bearing and in a ball bearing at the back. The spindle has a ball bearing at either end. The head can be telescopically extended up to 3" by loosening, knurled nut. Handpiece is available with both 3/32" and 1/8" collet (3/32" collet supplied unless otherwise specified). Comes with two spanner wrenches for tightening the tools in the collet. 1 MC works better with carbide cutters. Lubrication required. DIMENSIONS - OA Length 7 3/4" - Extended 10 7/8" - top of Head to Collet 1 3/8".

$335.00

2MC HEAVY DUTY HANDPIECE is designed with larger bearings spaced out close to each end and one piece shaft to hold close tolerance, especially designed to accommodate long shank carbide and heavy loading. Handpiece has sealed bearings with dust covers and comes with precision 1/4" collet (unless otherwise specified). All collet sizes available from 1/16" to 1/4". No Lubrication required. Extra Collets &17.50 ea.

$150.00

NO. 44 MC TAPER is for all general work with shank sizes up to 1/4". Has a 1-piece shaft with sealed ball bearings and should not be lubricated. Comes with wrench and pin for changing collets (1/4" collet supplied unless otherwise specified). Collet set available $38.00. Extra Collets $6.00 ea.. Replaces 44mc taper.

$54.00

NO. 8 MC handpiece has grease sealed ball bearings for heavier duty. An ideal alternate to the No. 7MC handpiece if working areas are large enough to permit its use (11/16" at collet end). A collet-type chuck takes four sizes of collets, available in collet set. Comes complete with one collet (3/32" unless otherwise specified). Collet set #600 includes 4 sizes in 1/32" increments from 1/32" to 1/8" - $18.00. Extra collets $6.00 ea.

$57.00